Battery connector wires are usually color coded red for positive and black for negative and the same would be true for the power leads (wires) inside the RC that run from the circuit board to the battery compartment. But this is not always the case. The RC sub used in this tutorial has two positive wires that are purple and orange and one black negative wire. You may also encounter variations in the wiring for your own RC.
Modifying an Electric RC to Use a Quick-Charge Battery Pack
By Michael James, About.com Guide
Disassemble the RC, Trace the Wires
Wires aren't always red and black so trace them back to the circuit board to be sure which is positive and negative.
Photo © M. James
Take apart your RC, if necessary, in order to trace the wires from the battery compartment back to the circuit board. On the circuit board it should be labeled as to which is positive (+) and which is negative (-).
Prev
- Multiple Batteries vs. Single Battery Pack
- What You Need
- Choose the Right Battery and Connector
- Disassemble the RC, Trace the Wires
- Prepare for Soldering
- Solder the Wires
- Make Slots for the Wires
- Install the Battery Pack
Working on Your Electric RC
Explore Radio Controlled Vehicles
Must Reads
About.com Special Features
Holiday Central
What to eat, where to go, fun things to do and how to save money on the perfect gifts. More >
Scrapbook Technique Gallery
Use these ideas to inspire your own uniquely beautiful pages. More >
©2009 About.com, a part of The New York Times Company.
All rights reserved.